
Spicer
®
Steer Axles
ABIB-0505
Information Bulletin
Bulletin Type: Parts
Topic: Converting Single Draw Key Steer Axles to Dual Draw Key Configuration
Affected Models: E-1200I, E-1320I, E-1460I (3.5” Drop Beams Only)
• This bulletin is a revision to and replaces bulletin number ABIB-0208.
If converting a Dana steer axle from a single draw key design to a dual draw key design, a new beam along with a
kingpin service kit is required. Use the conversion charts below as they list the most current “E” series single draw
key steer axle beam part numbers and the new “Dual Draw Key” equivalent beam along with the required kingpin
hardware kit.
DUAL DRAW
KEY KINGPIN
Single Draw Key
OEM
Dual Draw Key
KIT
815319 Western Star 971698
815322 Peterbilt
971699
816247 International
971700 328348
816251 Freightliner
971701
(NOTE 1)
818835 Freightliner 972014
816944 Kenworth 971702
970862** Peterbilt
N/
A
819185 Mack 971703
DUAL DRAW
KEY KINGPIN
Single Draw Key
OEM
Dual Draw Key
KIT
818035 International
971700
818036 Freightliner 971701 328348
818041 Kenworth
971702
(NOTE 1)
818284 *** Kenworth
N/
A
818287 *** Western Star
N/
A
970878 Mack 971703
DUAL DRAW
KEY KINGPIN
Single Draw Key OEM Dual Draw Key KIT
817656 Kenworth
971620
817648 Peterbilt
971621 328349
818291 Peterbilt
1462TB107 2
818963 Western Star 971622
(NOTE 1)
970603 Freightliner
971623
E-1460I Models
E-1200I Models*
E-1320I Models
NEW SPICER BEAM P/N
*** 5" Drop Beam w/ Small Pin Bore - Not Convertible.
NEW SPICER BEAM P/N
*NEW SPICER BEAM
P/N
ORIGINAL
PRODUCTION
BEAM P/N
ORIGINAL
PRODUCTION
BEAM P/N
ORIGINAL
PRODUCTION
BEAM P/N
** This is a Wide Track Design Beam
*E-1200I “Dual Draw Key” beams are 30
lbs heavier than original design.
NOTE 1: THE SERVICE KIT LISTED CONTAIN
"GARLOCK DX" PRE-SIZED KINGPIN BUSHINGS.
SERVICE KITS WITH OPTIONAL "BRONZE"
BUSHINGS ARE AVAILABLE. SEE PAGE 2 OF THIS
BULLETIN FOR PART NUMBERS.
This bulletin contains product information.
Dana Corporation is not committed or liable for canvassing existing product.
Comentarios a estos manuales